Stainless steel has always presented a challenge in terms of cutting it on a router table. Due to its tough physical properties it is extremely difficult to route and damaging tools. The NEW Onsrud 83-305, 310, 315 and 320 ALTiN series of router bits combats the challenge presented by stainless steel, and has opened up a wide range of new routing possibilities. This is a solid carbide upcut spiral tool that is coated in AlTiN to add the required strength to cut through stainless steel. This tool possesses the special cutting geometry that is needed to make the cut as well as to increase tool life.

These router bits are available through MultiCam Canada. Direct any questions or orders to 905-738-7954 or email [email protected].


No responses yet

Leave a Reply

Your email address will not be published. Required fields are marked *

join our newsletter